50ua Current Drives Solid State Relay Requires Only

Most solid state relays require at least 5ma and often more input control current, to fully turn on the device.  But such current levels often force battery powered circuits to use excessively large batteries.  The relay hobby circuit shown below demands only 50uA of input current.

Comments

Post a Comment

Popular posts from this blog

HIGH PASS ACTIVE FILTER COLLECTION

Image
This is a collection of inverting and non-inverting active high pass filter circuits.  I included one, two three, four and six pole filter circuits.  You can change the component value ratios shown to achieve any frequency cut-off you may need. The circuit does not specify an operational Amplifier.  The circuits should be used to select the needed resistor and capacitor components for a particular frequency knee and  slope.
Read more