AUDIO AMP + 3KHz FILTER

This circuit is the audio Amp section for a complete optical transmitter.   The circuit Amplifies and filters the voice audio signals from an electret microphone.  The circuit is described in more detail in the receiver section of Dave Johnson's.

Comments

Post a Comment

Popular posts from this blog

HIGH PASS ACTIVE FILTER COLLECTION

Image
This is a collection of inverting and non-inverting active high pass filter circuits.  I included one, two three, four and six pole filter circuits.  You can change the component value ratios shown to achieve any frequency cut-off you may need. The circuit does not specify an operational Amplifier.  The circuits should be used to select the needed resistor and capacitor components for a particular frequency knee and  slope.
Read more

60Hz Notch Filter

Image
High input impedance Amplifiers are ideal for buffering high impedance networks. Here a twin-T notch filter is shown to reject 60Hz signal content by more the 60dB. Small size, low valued capacitors can be used at such a low frequency with high valued resistors when using a CMOS op Amp… 
Read more